021-64709140

latest Announcement:

       Brand of influence of decoration equipment  

       Yasumoto Industry Coating (Shanghai) Co., Ltd.,

Press Center

news center

The use and maintenance of airless spraying equipment

Date:2017-08-23 20:55:01

     (1) airless spraying equipment use precautions
        1) The pressure used in the spraying operation should be lower than the maximum pressure allowed by the equipment. Low pressure should be used as far as possible to avoid excessive scattering of fog and excessive damage to the wearing parts.
        2) The work should be carried out when no-load operation or cleaning should be low pressure, if the pressure is too high, moving parts and gasket easy to premature damage.
        3) with compressed air as a power source, avoid mixing air into the water, to prevent the drive parts rust, damage the cylinder.
        4) paint can not be mixed with dust and foreign matter, to ensure that the paint nozzle flow, to avoid clogging, paint the best before use to filter.
        5) After the day of spraying operation or replacement of paint varieties, should be removed spraying equipment and pipelines within the residual paint, the best day limit the use of a coating.
        6) spray the end of the nozzle and filter must be clean, so as not to residual paint dry solidification, plug the nozzle. It is advisable to remove the nozzle and soak it in the solvent.
        7) high-pressure pump seal gasket and valve and other wearing parts, should always check, timely detection of hidden dangers, if damaged should be replaced.
        8) Paint delivery pipe as far as possible not to extreme bending, so as not to lead to unnecessary pressure loss. Bending radius is too small, will also affect the service life of the pipeline.
        9) Do not use spray gun spray solvent, solvent spray can easily lead to explosion after the fire accident, and harmful to human health.
        10) Pneumatic high pressure pump noise is very high, the exhaust pipe should be set muffler, try to reduce noise.
        11) airless spray paint pressure is high, spraying to be particularly careful, do not shoot the body, so as not to cause harm.
        12) Airless spray equipment and paint delivery piping must be grounded. Paint from the spray gun high-speed spray, will naturally produce static electricity, and gathered in the spraying equipment and coating surface, therefore, must take grounding measures to eliminate static electricity, to avoid spark discharge caused by fire.
       (2) the use of airless spray equipment failure and troubleshooting measures
        Airless spraying equipment should always check the use of equipment, always found fault, and take appropriate measures to eliminate. Common use of the failure and troubleshooting measures in the table below.

Yasumoto Industry Coating (Shanghai) Co., Ltd.,Copyright ownership